您好,欢迎访问济南凯轩鹏宇玻璃有限公司 网站

全国咨询热线:

400-9968-996

当前位置:首页>新闻资讯>行业动态玻璃门常见的5个问题

玻璃门常见的5个问题

文章出处:http://www.jnkdblgd.com/ 人气: 0 发表时间:2022-11-18
为了美观性,也为了通透感和亮度,家里的浴室与厨房选择了推拉玻璃门作为隔断。下面济南玻璃门厂家来讲讲玻璃门常见的5个问题。
For the sake of beauty, transparency and brightness, the bathroom and kitchen at home choose sliding glass doors as partitions. Next, Jinan glass door manufacturer will talk about 5 common problems of glass doors.
一、异常的声响
1、 Abnormal sound
倘若开关门时有声音,玻璃门下垂,很可能是地弹簧坏了。一旦发现,须及时处理。不然,地弹簧和门框会严重毁坏,甚于玻璃门也会因压力过大或摩擦力过大而出现破裂和受损。轮滑是玻璃门的关键零部件,倘若出现故障,不但使用麻烦,并且会产生噪音。
If there is a noise when opening and closing the door, and the glass door droops, it is likely that the floor spring is broken. Once found, it shall be handled in a timely manner. Otherwise, the floor spring and door frame will be seriously damaged, and even the glass door will be cracked and damaged due to excessive pressure or friction. Wheel slide is a key component of glass door. If it fails, it will not only cause trouble, but also generate noise.
二、拉手脱落
2、 Handle falls off
一旦使用时间太长,拉手是比较容易坏的,因为它平常接触得多,会承受很大的重力,长时间的磨损很容易让它脱落。维修时,先将玻璃门取下,再拆换为新拉手。
Once the handle is used for too long, it is easy to break, because it usually contacts too much and will bear a lot of gravity, and it is easy to fall off due to long-term wear. During maintenance, remove the glass door first, and then replace it with a new handle.
三、玻璃门不能正常滑动
3、 The glass door cannot slide normally
门扇使用一段时间后,也会出现一些或大或小的问题,有时候会感觉到很钝感,通常是弹簧出了问题,那么只需拆换一个承重性较好的弹簧便可。查看其滑槽内是否有杂物,使其不能正常滑动。,清理滑槽内的杂物,看它是否能正常滑动。假若不行,查看滑槽是否生锈。在这种情况下,往滑槽内添加一些润滑剂类的东西或者是对滑槽除锈。
After the door leaves have been used for a period of time, some big or small problems will also occur, and sometimes they will feel very dull. Usually, there is a problem with the spring, so it is only necessary to replace a spring with good load-bearing performance. Check whether there are sundries in the chute to prevent it from sliding normally. First, clean the debris in the chute to see if it can slide normally. If not, check the chute for rust. In this case, add some lubricant to the chute or remove rust from the chute.
这时,还需要检查轮滑的受损程度是否严重。可以拆换有问题的部件,或直接拆换整个轮子,使玻璃门恢复正常工作状态。
At this time, it is also necessary to check whether the damage of the roller slide is serious. The defective parts can be replaced, or the entire wheel can be directly replaced to restore the glass door to its normal working state.
济南玻璃门
四、门关不严
4、 The door is not closed tightly
在使用玻璃门时,常见的问题是门关不上,或者门关闭时,对不上正确的位置上,出现偏差。查看玻璃门夹是否松动,松动就可以加一个到两个皮垫子,用螺丝刀拧紧。倘若玻璃门夹坏了,拆换玻璃门夹。然后再调节闭门器的液压阀,闭门器关门力量太小也会导致门关不严。
When using glass doors, the common problem is that the door cannot be closed, or when the door is closed, it cannot be aligned to the correct position, resulting in deviation. Check whether the glass door clamp is loose. If it is loose, one or two leather cushions can be added and tightened with a screwdriver. If the glass door clip is damaged, remove and replace the glass door clip. Then adjust the hydraulic valve of the door closer. If the closing force of the door closer is too small, the door will not be closed tightly.
五、玻璃门框以及玻璃门固定框出问题
5、 There is a problem with the glass door frame and its fixing frame
玻璃门框以及玻璃门固定框使用时间过长,可能会出现磨损。倘若磨损程度大,玻璃需要拆卸下来处理,这将是一项大工程。这类问题,小编建议大家咨询专门的玻璃门维修店维修,或是拆换玻璃门框或是玻璃门固定门框。
The glass door frame and the glass door fixing frame may be worn if they are used for a long time. If the wear degree is large, the glass needs to be disassembled for treatment, which will be a big project. For this kind of problem, I suggest you consult a special glass door repair shop for maintenance, or replace the glass door frame or fix the glass door frame.
定期检查玻璃门的小部件,如轮滑,路轨清理等。若采用推拉开合方式,应定期上润滑油,使玻璃门开合更平稳流畅。更多相关内容欢迎来我们网站http://www.jnkdblgd.com进行咨询了解!
Regularly check the small parts of glass door, such as wheel slide, rail cleaning, etc. If the sliding opening and closing mode is adopted, lubricating oil shall be applied regularly to make the glass door open and close more smoothly. Welcome to our website for more information http://www.jnkdblgd.com Ask about it!