您好,欢迎访问济南凯轩鹏宇玻璃有限公司 网站

全国咨询热线:

400-9968-996

当前位置:首页>新闻资讯>公司新闻安装超大玻璃必须知道的那些事!

安装超大玻璃必须知道的那些事!

文章出处:http://www.jnkdblgd.com/ 人气: 0 发表时间:2023-06-05
近几年,门窗市场出现了越来越多的超大玻璃产品。安装超大玻璃可以增加观景视野,提高居住档次和体验,但其在一定程度上存在玻璃自爆及施工安装所带来的隐患,需要格外注意。下面济南玻璃安装人员为您分析:
In recent years, an increasing number of oversized glass products have emerged in the door and window market. Installing oversized glass can increase the viewing field, improve the living quality and experience, but to some extent, there are safety hazards caused by glass self explosion and construction installation, which require special attention. Below, Jinan glass installation personnel will analyze for you:
隐患一:设计风险
Hazard 1: Design risk
超大玻璃的安装现场比较复杂,对型材、五金配件等要求更高,此外,玻璃也要加厚的,甚夹胶也要做好几层。因此,一方面需要从设计方案上规避风险,另一方面要确定现场环境是否具备安装条件。
The installation site of oversized glass is relatively complex, with higher requirements for profiles, hardware accessories, etc. In addition, the glass also needs to be thickened, and even several layers of adhesive must be made. Therefore, on the one hand, it is necessary to avoid risks from the design scheme, and on the other hand, it is necessary to determine whether the on-site environment meets the installation conditions.
隐患二:运输风险
Hazard 2: Transportation Risk
运输问题也是使用超大玻璃的难题之一,很容易出现在运输中碰撞、搬运破损等问题。建议尽量选用专车直送到工地,减少转运的次数以降低破损风险。
The transportation problem is also one of the difficulties in using oversized glass, which can easily occur during transportation, such as collisions and damage during transportation. It is recommended to use specialized vehicles as much as possible to deliver directly to the construction site and reduce the number of transfers to reduce the risk of damage.
济南玻璃安装
隐患三:吊装风险
Hazard 3: Hoisting risk
将超大玻璃运上楼,尤其是高层,想想就会让人提心吊胆。在吊装过程中稍不注意,就会发生破损、脱落、碰撞、落地撞角等问题。
Transporting oversized glass upstairs, especially in high-rise buildings, can be scary to think about. If you don't pay attention during the lifting process, problems such as damage, detachment, collision, and landing collision may occur.
好的应对方法如下:
A good response method is as follows:
吊装前准备好对接好施工现场以及绳,路障堆头,木方垫块等工具,安装措施设备;请的吊装设备团队进行吊装,玻璃四边护角进行保护处理;吊装时进行现场清理封闭,无人行车辆经过进行吊装,吊装过程中注意施工环境,勿碰角。玻璃落地下方要垫木方;
Before lifting, prepare and connect the construction site, safety ropes, road blocks, wooden blocks, and other tools, as well as installation measures and equipment; Please have a professional lifting equipment team carry out the lifting, and protect the glass corners on all four sides; During lifting, the site should be cleaned and sealed, and unmanned vehicles should pass by for lifting. During the lifting process, pay attention to the construction environment and avoid touching corners. Wooden blocks should be placed below the glass floor;
隐患四:安装风险
Hazard 4: Installation Risk
在安装过程中会存在安装移动撞角、受力不均、安装人工搬运抬玻璃上框等风险,安装在阳台还要考虑原建筑结构承重的问题。对此,提醒做好如下工作:
During the installation process, there may be risks such as installation movement collision angles, uneven force distribution, and manual lifting of glass frames during installation. When installing on the balcony, it is also necessary to consider the bearing capacity of the original building structure. In this regard, we remind you to do the following work well:
制定好安装方案以及计划;安装前现场清理干净,施工现场开阔无杂物;安装前准备好绳,玻璃吸盘4-8个不等根据玻璃大小而定,人员组织;人工搬运6mm厚度以下,长度超过2米的玻璃时,需由多人搬台,大件玻璃切勿平抬翻动及搬动;
Develop a safe installation plan and plan; Clean the site before installation, and ensure that the construction site is open and free of debris; Prepare safety ropes before installation, with 4-8 glass suction cups depending on the size of the glass, and organize personnel accordingly; When manually transporting glass with a thickness of less than 6mm and a length of more than 2 meters, it is necessary to have multiple people move the table. Large pieces of glass should not be lifted, flipped or moved flat;
人工抬玻璃上框以矩形玻璃为依据,一半根据玻璃厚度和尺寸估算,决定搬动,普通情况下人工搬运重量为25KG以下为原则。“按照的标准,每平方阳台的承重能力需要达到250公斤,它的设计单位是每平方kn。如果超出了250公斤会存在隐患。
The manual lifting of the upper frame of the glass is based on rectangular glass, and half of it is estimated based on the thickness and size of the glass, and the decision to move is made. In general, the principle of manual handling is that the weight is less than 25KG. According to national standards, the load-bearing capacity of each square meter balcony needs to reach 250 kilograms, and its design unit is per square meter. If it exceeds 250 kilograms, there will be safety hazards.
隐患五:使用风险
Hazard 5: Use Risk
型材下垂、玻璃自爆、自爆后掉落砸人砸物、售后成本增加都是常见的风险。因此,需要防患于未然,设计时型材中间考虑加钢衬;提高玻璃指数,建议超大玻璃外面做夹胶中空,通过均质处理的超白玻璃,降低玻璃自爆率。
The common risks include profile sagging, glass self explosion, falling after self explosion, smashing people and objects, and increased after-sales costs. Therefore, it is necessary to take preventive measures and consider adding steel lining in the middle of the profile during design; To improve the safety index of glass, it is recommended to use laminated insulation on the outside of oversized glass, and to reduce the self explosion rate of glass by homogenizing the treated ultra white glass.
其他注意事项:
Other precautions:
玻璃太大要加厚,对厂家设备有要求,也高,需要做好充足预算;
If the glass is too large, it needs to be thickened, which has requirements for the manufacturer's equipment and high prices. It is necessary to have a sufficient budget;
窗型选择,铝材厚度少1.8mm以上,主框上悬臂深度少22mm,玻璃压线要用闭口压线;
Window type selection, with an aluminum thickness of at least 1.8mm and a cantilever depth of at least 22mm on the main frame. The glass pressing line should use a closed pressing line;
自爆率高,玻璃的自爆几率大约是千分之三,玻璃越大,自爆几率越高;建议选超白玻以及经过均质处理,自爆几率会降低。对此,还有什么疑惑或者需求就来我们网站http://www.jnkdblgd.com咨询!
The self explosion rate is high, and the self explosion probability of glass is about three thousandths. The larger the glass, the higher the self explosion probability; It is recommended to choose ultra white glass and undergo homogenization treatment to reduce the probability of self explosion. If you have any doubts or needs regarding this, please come to our website http://www.jnkdblgd.com consulting service