High compartment is the first choice for office partition decoration. After the installation of glass partition, we still need to pay attention to daily cleaning and maintenance in the process of using glass partition. The main instructions are as follows:

办公室高隔间的墙体框架分为两种表面，一种是阳极氧化铝合金，可清洗，绝不生锈、不腐蚀，布面板仅可用干布擦拭，或用特殊清洁喷剂，不可沾水清洗;除布面板外其余标准面板均可清洗，清洗时不要选用有磨料、强酸成份的清洁剂，以免损伤表面。还有一种是钛镁闪银铝合金，施工过程中或者客户在使用中不小心磨花，蹭伤，可直接在当地购同色自喷漆处理，表面成崭新的不留任何一点磨伤的花纹，从而帮您降低成本。

The wall frame of the high compartment of the office is divided into two surfaces. One is anodized aluminum alloy, which can be cleaned without rust and corrosion. The cloth panel can only be wiped with a dry cloth or special cleaning spray, and can not be cleaned with water; Except cloth panels, other standard panels can be cleaned. Do not use cleaning agents with abrasive and strong acid components to avoid damaging the surface. The other is titanium magnesium flash silver aluminum alloy. If it is scratched or scratched carelessly during construction or when the customer is in use, it can be directly purchased locally with the same color self painting treatment, and the surface will be a brand-new pattern without any abrasion, so as to help you reduce the cost.

在清洁玻璃隔断的过程中，要或减少脏污，请使用清洁剂，或其它温和的清洁剂清洁，以微湿的软布吸干清洁剂，然后再以水清洗。以适当的溶剂及油漆、釉、及天然漆，这里需要注意的是，大多数溶剂都具高可燃性，致于水性漆料，则以氯清洁剂或去漆清洗。对于清洗不掉的顽渍，则使用塑料型、不具研磨性刷子刷即可，切勿使用其它金属制的铁刷。

In the process of cleaning the glass partition, to remove or reduce dirt, please use full-effect cleaner or other mild cleaner, dry the cleaner with a slightly wet soft cloth, and then wash with water. Use appropriate solvents and paints, glazes, and natural paints. It should be noted that most solvents are highly flammable. If water-based paints are caused, clean them with chlorine cleaner or paint remover. For stubborn stains that cannot be cleaned, use a plastic brush without abrasiveness. Do not use iron brushes made of other metals.

保养高隔间的时候我们一定要注意，不要以利器在高隔间墙体表面直接切、割、敲打、以免在表面留下刮痕、裂痕及沟孔。除布面板外其余标准面板均可清洗，清洗时不要选用有磨料、强酸成份的清洁剂，以免损伤表面。胶条是保证斯唯铝合金玻璃隔断密封，隔音和防水的关键，如有脱落要及时修补，更换。在使用过程中，应轻推轻拉，推拉顺其自然，变形是铝合金隔断老化的主要原因，要保持铝合金清洁，特别是拼接缝的清洁。可用吸尘器吸去槽内和胶条的积灰。

When maintaining the high compartment, we must pay attention not to use sharp tools to directly cut, cut and knock on the wall surface of the high compartment, so as not to leave scratches, cracks and grooves on the surface. Except cloth panels, other standard panels can be cleaned. Do not use cleaning agents with abrasive and strong acid components to avoid damaging the surface. The adhesive strip is the key to ensure the sealing, sound insulation and waterproof of Svay aluminum alloy glass partition. If it falls off, it shall be repaired and replaced in time. During use, push and pull gently. Push and pull naturally. Deformation is the main reason for the aging of aluminum alloy partition. Keep the aluminum alloy clean, especially the joint. The dust accumulated in the groove and the rubber strip can be sucked with a vacuum cleaner.