With the development of Jinan automatic induction door enterprises, automatic doors can be seen almost everywhere. Automatic door is deeply loved by users because of its beautiful, simple shape, high cost performance and many other advantages. However, on the other hand, there are some disadvantages. Since automatic doors are frequently used in daily life, users need to pay attention to regular inspection in daily life. It is necessary to ensure its normal use at any time, but what details should relevant personnel pay attention to during automatic door inspection? How to check the automatic door?

1.，测试仪应以正常速度从门的外部或内部移动到自动门，自动门将自动打开。自动门动作平稳，无碰撞;自动门打开后，测试仪应以大约150mm-200mm/s的速度缓慢通过自动门，然后自动门应保持打开状态;

1. First, the tester shall move from the outside or inside of the door to the automatic door at normal speed, and the automatic door will open automatically. The automatic door operates stably without collision; After the automatic door is opened, the tester shall slowly pass through the automatic door at a speed of about 150mm-200mm / s, and then the automatic door shall remain open;

2.检查人员离开济南自动门传感器检测区域后，自动门传感器延时1-10秒自动关闭(延时可根据使用环境和流量合理设置，自动门动作平稳无碰撞;

2. After the inspectors leave the detection area of Jinan automatic door sensor, the automatic door sensor will automatically close after a delay of 1-10 seconds (the delay can be reasonably set according to the use environment and flow, and the automatic door will operate smoothly without collision;

3.观察者以正常速度通过自动门的行走路线需要调整每日行走路线，使人面向自动门，而不是以一定角度朝自动门行走;当移动到自动门时，自动门传感器的感应宽度范围应大于整个门的宽度;

3. The observer's walking route through the automatic door at normal speed needs to adjust the daily walking route so that people face the automatic door rather than walking towards the automatic door at a certain angle; When moving to the automatic door, the sensing width range of the automatic door sensor shall be greater than the width of the whole door;

4.如果辅助安 全光传感器安装在自动门中，当自动门的门扇打开时，人们站着不动，用手盖住辅助安 全光传感器，门应保持打开。手离开后几秒钟内，门应再次关闭。

4. If the auxiliary safety light sensor is installed in the automatic door, when the door leaf of the automatic door is opened, people stand still and cover the auxiliary safety light sensor with their hands, and the door shall remain open. The door shall be closed again within a few seconds after the hand leaves.

济南自动感应门需要检查自动门的开启和关闭速度、自动门的行走路线、门的灵敏度等。总之，检查人员需要得到正确的结果，以保持自动门开启和关闭的安 全，并做好工作，这样每个人在使用时都会为安 全。

Jinan automatic induction door needs to check the opening and closing speed of the automatic door, the walking route of the automatic door, the sensitivity of the door, etc. In short, the inspectors need to get the correct results to keep the safety of opening and closing the automatic door, and do a good job in solving the problem, so that everyone will be safe when using it.