肯德基门听字面意识就是到是肯德基店面的所装的门，但是它还有另外一层意思，像是咖啡厅、、酒店等场所的门，在行业内都统称为肯德基门，因为它造型时尚高雅、醒目大气，所以很多的店面铺子也都会选择肯德基门使用，那么你知道济南肯德基门是怎么安装的吗？

KFC doors literally mean that they are the doors installed in KFC stores. However, they also have another meaning, such as the doors of coffee shops, shopping malls, hotels, and other places. They are collectively referred to as KFC doors in the industry. Because of their fashionable and elegant design, striking atmosphere, many stores also choose to use KFC doors. Do you know how Jinan KFC doors are installed?

一、安装肯德基门的步骤

1、 Steps for installing KFC doors

1、清扫门洞

1. Clean the door opening

清理门洞，剔除多余部分、保证门框两侧都在垂直线上，清扫完成后在安装门扇前也要在检查一遍。

Clean the door opening, remove excess parts, and ensure that both sides of the door frame are on the vertical line. After cleaning is completed, it is also necessary to check again before installing the door leaf.

2、固定门框和地轴

2. Fixed door frame and floor axis

用螺丝或柳钉组合门框的三支型材，然后固定门框与墙体之间的连接，地轴需要行固定，固定地轴时从顶轴的中心线垂直地轴轴承的中心，在地面开出与地轴盒长、宽、高度相符的尺寸，用螺丝或水泥沙浆固定好地轴。

Use screws or willow nails to combine the three profiles of the door frame, and then fix the connection between the door frame and the wall. The ground axis needs to be fixed first. When fixing the ground axis, it should be perpendicular to the center line of the top axis to the center of the ground axis bearing, and a size that matches the length, width, and height of the ground axis box should be opened on the ground. Fix the ground axis with screws or cement mortar.

3、安装肯德基门

3. Install KFC doors

松开肯德基门门扇上的防盗卡位螺丝，抽出上轴的轴心部分，在地轴轴承上抹上润滑油保证门扇开合流畅，这样做一定程度上可以增加门扇使用寿命。

Loosen the anti-theft locking screws on the KFC door leaf, pull out the axis part of the upper shaft, and apply lubricating oil on the ground shaft bearing to ensure smooth opening and closing of the door leaf. This can to some extent increase the service life of the door leaf.

4、调试门扇

4. Debugging the door leaf

若门扇的高低间隙有问题，可通过调试下轴上的内六角螺丝来调整，顺时针调试可使门扇上升，逆时针调试则使门扇下降；要对门扇的方向进行调整，打开地轴盒的盖板，用扳手调节地轴的螺丝就行。

If there is a problem with the high and low clearance of the door leaf, it can be adjusted by adjusting the inner hexagonal screw on the lower shaft. Clockwise adjustment can make the door leaf rise, while counterclockwise adjustment can make the door leaf fall; To adjust the direction of the door leaf, open the cover of the floor axis box and use a wrench to adjust the screws of the floor axis.

5、安装闭门器

5. Install door closer

紧牢防盗卡位螺丝，进行闭门器的安装，可根据闭门器配套说明书安装并调试闭门器，闭门器调试完成无问题，就算安装成功。下面来看看安装肯德基门的注意事项吧。

Tighten the anti-theft detent screw and install the door closer. You can install and debug the door closer according to the door closer matching instructions. If the door closer is debugged without problems, the installation is successful. Let's take a look at the precautions for installing KFC doors.

安装肯德基门的注意事项：

Precautions for installing KFC doors:

1、注意安装的顺序，不要出现装好再拆的现象，各个地方的螺丝都要拧紧。

1. Pay attention to the installation sequence, do not install and then remove, and tighten the screws in all places.

2、在做安装的清理工作时要到位，不要让不该留的东西留在门洞或者门缝里。

2. When doing installation cleaning work, it is necessary to be in place and not leave anything that should not be left in the door opening or crack.

3、固定地轴的之后，等水泥干了进行下一步，保证坚固度。

3. After fixing the ground axis, wait for the cement to dry before proceeding to the next step to ensure firmness.

4、施工时，应严格做好产品保护，损坏的保护胶带和保护膜应及时密封，溅在铝门窗表面的砂浆污垢应及时。

4. During construction, product protection should be strictly carried out, damaged protective tape and film should be sealed in a timely manner, and mortar dirt splashed on the surface of aluminum doors and windows should be removed in a timely manner.

5、肯德基门安装完成后要检查对角线和平整度偏差，门进入后用钢尺和塞尺检查框扇的搭接宽度和周边间隙，直符合要求。

5. After the installation of KFC doors is completed, the diagonal and flatness deviation should be checked. After the door enters, use a steel ruler and a feeler gauge to check the overlapping width and surrounding clearance of the frame and leaf until they meet the requirements.

我们在安装肯德基门时，可以使用以上方法来进行安装，同时在安装中要注意好安装的顺序，不要搞错，施工中溅射在门窗上的污渍要及时干净，免得影响美观。您有安装需求可以随时来咨询我们http://www.jnkdblgd.com！

When installing KFC doors, we can use the above methods for installation. At the same time, we should pay attention to the installation sequence and avoid making mistakes. The stains splashed on the doors and windows during construction should be promptly removed to avoid affecting the aesthetics. You can always consult us if you have installation requirements http://www.jnkdblgd.com ！